Best answer: How do I make my beads wider?

How do you widen beads without a reamer?

You don’t have to purchase a bead reamer. A few things you can use: a safety pin, a toothpick, a paper clip or bobby pin, darning needle, anything with a point that will slide through the beading hole easily.

How do you make pearl bead holes bigger?

However, if you’d like to use needle and thread again for your next design, use a pearl reamer to make the drill holes larger. These handy tools come with a very fine, tapered, corkscrew-like tip. Just pass the tip through the drill hole, hold onto the pearl and slide it back and forth to enlarge and smooth the hole.

How does a bead reamer work?

A bead reamer is a pointed, round file that is used to either smooth the edges of the drill hole in a bead or to widen the hole itself. Its important to always smooth the rough edges on a bead as they will wear the cord or wire of your design. … Twist the file in the hole until the edges are smooth.

How do you enlarge a hole in gemstone beads?

Jam your needle or wire through the bead, often resulting in frustration and a broken bead. Throw the bead over your shoulder (like with salt, it’s considered good luck). Use a tool, such as a bead reamer, to enlarge the hole.

THIS IS INTERESTING:  Question: How long does it take to do a quick weave?

How do you enlarge a hole in glass?

Take a really small screwdriver that can fit in the hole already and put it in. Then slowly push the hole outwards to make it bigger and every once in a while heat the glass up again if it cools down too much to push it outwards…